Interface Cards
Installing
This section contains two sets of instructions:
• "Installing" (page 6-45)
• "Removing" (page 6-49).
These instructions apply to both the 10Base2 Ethernet and the
Token Ring Interface Cards. The Token Ring Card is illustrated
here.
Follow the procedure below to install an interface card. To
install the card you will need either a Phillips head
screwdriver or a hex-head nut driver.
1
Power OFF the printer.
2
Disconnect the GFI power cord from the printer.
Discharge any static electricity from your
body before continuing with the next step.
Chapter 6: Installing and Removing Printer Options
Interface Cards
6-45