Interface Cards
6-46
System Administrator Guide
Unpack the interface kit. It should include these items:
3
(1) Two hex-head screws notched for a Phillips head
screwdriver.
(2) The interface card.
4
Loosen the thumbscrews and pull out the controller
board. Set it on a flat surface.
Use the screw driver/nut driver to remove the two screws
5
holding the cover plate on the controller board as
illustrated. Set the screws and the cover plate aside.
These screws are the same as the screws packed
with the interface card. You will not need the
cover plate when the card is installed but you
should keep it in a safe place in case you remove
the card in the future.