Xerox DocuPrint N3225 System Administrator Manual page 202

Control Panel Messages
Table 5.2 Control Panel messages and corrective actions (continued)
Message
Check
Staple Cartridge
Check Toner
Cartridge
Clear Area A
Clear Env/Bypass
Clear Area A
Reset Tray 1
Clear Area B
Reset Tray 2
Clear Area C
Reset Tray 4
Clear Area C
Reset Tray 5
5-10 System Administrator Guide
Description/Corrective Action
The Stapler cartridge is not in position. Verify that the Stapler cartridge has
been installed. and that it contains staples.
The Laser Print Cartridge is not seated correctly. Reseat the Laser Print
Cartridge. See "Replacing the Laser Print Cartridge" (page 4-2) for installation
instructions.
A paper jam has occurred in Area A. Clear the Envelope Feeder or the Bypass
Feeder. Then reset Tray 1.
A paper jam has occurred in Area A. Use one of the following procedures to
clear Area A:
• "Clearing Area A (Without Duplex Module)" (page 5-33), or
• "Clearing Area A (With Duplex Module)" (page 5-35).
Then reset Tray 1.
A paper jam has occurred in Area B. Clear Area B (page 5-37). Then reset Tray
2.
A paper jam has occurred in Area C. Clear Area C (page 5-37). Then reset
Tray 4.
A paper jam has occurred in Area C. Clear Area C (page 5-37).Then reset Tray
5.
Table 5.2 Page 6 of 24