Duplex Module
Installing
This section contains two sets of instructions:
• "Installing" (page 6-9)
• "Removing" (page 6-14)
Follow the procedure below to install the Duplex Module
onto a printer that is already in service. If installing onto a
printer that has not been set up with the Face-up Bin and
powered ON, start with Step 7 on page C-13.
1
Power OFF the printer.
2
Disconnect the GFI power cord from the printer.
3
Remove the Face-up Bin and its connecting plate from the
printer.
Chapter 6: Installing and Removing Printer Options
Duplex Module
6-9