Xerox DocuPrint N3225 System Administrator Manual page 208

Control Panel Messages
Table 5.2 Control Panel messages and corrective actions (continued)
Message
Initializing...
Initializing...
Flash Memory
Insert Tray 1
Insert Tray 2
Insert Tray 3
Insert Tray 4
Insert Tray 5
Install
Print Cartridge
Install
Staple Cartridge
IOT Memory Fail
Power Off/On
5-16 System Administrator Guide
Description/Corrective Action
This message appears for a few seconds while the printer is initializing.
The printer is initializing the flash memory.
The printer cannot feed from Tray 1. Make sure Tray 1 is properly inserted in
the printer.
The printer cannot feed from Tray 2. Make sure Tray 2 is properly inserted in
the printer.
The printer cannot feed from Tray 3. Make sure Tray 3 is properly inserted in
the printer.
The printer cannot feed from Tray 4. Make sure Tray 4 is properly inserted in
the printer.
The printer cannot feed from Tray 5. Make sure Tray 5 is properly inserted in
the printer.
The Laser Print Cartridge is missing or is not installed correctly. Re-install the
existing Cartridge or install a new one. If the problem persists, contact your
Customer Support Center.
The Finisher is out of staples. Remove the empty Staple Cartridge and install
a new one. Refer to the section "Adding Staples to the Finisher" in Chapter 4
of the User Guide.
The Print Engine (IOT) memory has failed and printing cannot resume.
Power OFF and ON the printer. If this message reappears, contact your
Customer Support Center.
Table 5.2 Page 12 of 24