Xerox DocuPrint N3225 System Administrator Manual page 290

Interface Cards
6-48 System Administrator Guide
Align the two screw receptacles on the interface card with
8
the slots in the front of the controller board and insert the
screws. Tighten the screws using either a nut driver or
Phillips head screwdriver.
Use either the screws that you removed from the
controller board earlier, or the two screws that
were packed with the interface card.
9 Replace the controller board and tighten the thumbscrews
by hand.
10 Re-attach the GFI power cord to the printer. Reattach any
cables to printer ports.
11 Power ON the printer.
12 Print a Configuration Sheet. (page 3-91) and confirm that
the proper Network Interface appears on the sheet.
If the proper interface does not appear on the
Configuration Sheet or if an error message
appears, perform steps 1 through 5 of the next
section "Removing". Then reinstall the card and
print another Configuration Sheet. If the proper
interface still does not appear on the sheet or the
error message is still present, contact your
Customer Service Center.