Xerox DocuPrint N3225 System Administrator Manual page 199

Table 5.2 Control Panel messages and corrective actions (continued)
Message
†
0006 -COMM
† Appears in the upper left
corner of the display.
†
0007 -ASIC
† Appears in the upper left
corner of the display.
†
0008 -DMA
† Appears in the upper left
corner of the display.
†
0009 -ROM BOARD
† Appears in the upper left
corner of the display.
†
0010 -DISK
† Appears in the upper left
corner of the display.
†
0040
† Appears in the upper left
corner of the display.
†
0101 -DIMM1
† Appears in the upper left
corner of the display.
Description/Corrective Action
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred. Power OFF and Power ON the printer. If this
code appears again at Power ON, contact your Customer Support Center.
A fault condition has occurred in DIMM1.
1. Power OFF the printer.
2. Remove and reinstall DIMM 1.
3. Power ON the printer.
4. If the error code is redistilled, replace DIMM 1.
Refer to Figure 5.1 on page 5-29 for location of memory board.
Control Panel Messages
Table 5.2 Page 3 of 24
Chapter 5: Troubleshooting 5-7