Xerox DocuPrint N3225 System Administrator Manual page 218

Control Panel Messages
Table 5.2 Control Panel messages and corrective actions (continued)
Message
Remove Output
From Mailbox 9
Remove Output
From Mailbox 10
Replace Print
Cartridge
Reset ENV/Bypass
Reset Trays 2,3
ROS Trouble
Power Off/On
Slide In
Finisher
SNMP Resetting
Stapl Fail
Stapl Fail H5-91
Power Off/On
5-26 System Administrator Guide
Description/Corrective Action
The Mailbox 9 output bin is full. Printing cannot continue. Remove the
output from the Mailbox 9 output bin.
The Mailbox 10 output bin is full. Printing cannot continue. Remove the
output from the Mailbox 10 output bin.
The Laser Print Cartridge has reached its end of life. Printing cannot resume.
Replace the cartridge. See "Replacing the Laser Print Cartridge" (page 4-2).
A jam may have occurred in the Envelope Feeder or Bypass Feeder. Reset the
Envelope Feeder or Bypass Feeder.
A jam may have occurred in the Trays 2 and/or 3.
ACTION: Reset the trays.
This message indicates there is a problem with the ROS controlling ASIC.
Power OFF the printer and power it ON again. If the message appears again,
contact your Customer Support Center.
The Finisher guide rail is not entirely in position. Slide the guide rail into
position. Make sure it is securely snapped into the console. Check to see that
the thumb screw that connects it to the Finisher is hand tightened.
SNMP MIB data base is being re-initialized. Please wait.
Staple Failure. Power OFF and ON the printer.
The Staple Head did not return to its initial position. Power OFF and ON the
printer.
Table 5.2 Page 22 of 24