Xerox DocuPrint N3225 System Administrator Manual page 207

Table 5.2 Control Panel messages and corrective actions (continued)
Message
Fin Fail H5-85
Power OFf/On
Fin Fail H5-86
Power Off/On
Flash Error
Format Flash
Flushing...
Job name
Format Failed
Disk Locked
Fuser Fan
Failure
Fuser Temp.
Problem
Init Failed
Disk Locked
Description/Corrective Action
Finisher stacker upper limit switch problem. Power OFF and ON the printer.
Finisher stacker lower limit switch problem. Power OFF and ON the printer.
Displayed when Flash Memory error is found. Format flash memory as per
the instructions for "Flash Format" (page 1-105). If the problem persists,
contact your Customer Service Center.
The PostScript print job could not be printed and is being parsed out and
discarded. This message remains on the display until the job being flushed is
complete, which may require additional data to be sent from the host.
A problem occurred during disk formatting. Printing may continue, but use
of the disk is locked out. Try reformatting the disk again or replace it.
The printer's fuser fan has failed. Power OFF and ON the printer. If this
message reappears, Power OFF the printer and contact your Customer
Support Center.
The Fuser has failed; printing cannot resume. Power OFF and Power ON the
printer to see if the problem occurs again. If you have just replaced the Fuser
Cartridge, reseat it. If you have not replaced the maintenance kit, it may be
time to do so. See "Installing the Maintenance Kit" (page 4-9). If the problem
persists, contact your Customer Support Center.
This disk cannot be initialized because it has been locked via a PJL command.
Control Panel Messages
Table 5.2 Page 11 of 24
Chapter 5: Troubleshooting 5-15