Table of Contents
Advertisement
Table 35 Queue Setup: Add (continued)
LABEL
Apply
Cancel
10.5 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port number,
destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the ZyXEL Device forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly. Similarly, give low
priority to many large file downloads so that they do not reduce the quality of other applications.
Click Network Settings > QoS > Class Setup to open the following screen.
Figure 54 Network Settings > QoS > Class Setup
The following table describes the labels in this screen.
Table 36 Network Settings > QoS > Class Setup
LABEL
Add new Classifier
#
Status
Class Name
Classification
Criteria
DSCP Mark
802.1P Mark
VLAN ID Tag
P-873HNUP-51B User's Guide
DESCRIPTION
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to create a new classifier.
This is the index number of the entry.
This field displays whether the classifier is active or not. A yellow bulb signifies
that this classifier is active. A gray bulb signifies that this classifier is not
active.
This is the name of the classifier.
This shows criteria specified in this classifier, for example the interface from
which traffic of this class should come and the source MAC address of traffic
that matches this classifier.
This is the DSCP number added to traffic of this classifier.
This is the IEEE 802.1p priority level assigned to traffic of this classifier.
This is the VLAN ID number assigned to traffic of this classifier.
Chapter 10 Quality of Service (QoS)
145
Advertisement
Table of Contents
