Table of Contents
Advertisement
Chapter 10 Quality of Service (QoS)
Table 37 Class Setup: Add/Edit (continued)
LABEL
VLAN ID
To Queue Index
Apply
Cancel
10.6 The QoS Policer Setup Screen
Use this screen to configure QoS policers that allow you to limit the transmission rate of incoming
traffic. Click Network Settings > QoS > Policer Setup. The screen appears as shown.
Figure 56 Network Settings > QoS > Policer Setup
The following table describes the labels in this screen.
Table 38 Network Settings > QoS > Policer Setup
LABEL
Add new Policer
#
Status
Name
Regulated Classes
Meter Type
Rule
150
DESCRIPTION
If you select Remark, enter a VLAN ID number with which the ZyXEL Device
replaces the VLAN ID of the frames.
If you select Remove, the ZyXEL Device deletes the VLAN ID of the frames
before forwarding them out.
If you select Add, the ZyXEL Device treat all matched traffic untagged and add
a second VLAN ID.
If you select Unchange, the ZyXEL Device keep the VLAN ID in the packets.
Select a queue that applies to this class.
You should have configured a queue in the Queue Setup screen already.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
DESCRIPTION
Click this to create a new entry.
This is the index number of the entry.
This field displays whether the policer is active or not. A yellow bulb signifies
that this policer is active. A gray bulb signifies that this policer is not active.
This field displays the descriptive name of this policer.
This field displays the name of a QoS classifier
This field displays the type of QoS metering algorithm used in this policer.
These are the rates and burst sizes against which the policer checks the traffic
of the member QoS classes.
P-873HNUP-51B User's Guide
Advertisement
Table of Contents
