Table of Contents
Advertisement
Chapter 4 Tutorials
4.4.2 Using WPS
This section shows you how to set up a wireless network using WPS. It uses the ZyXEL Device as
the AP and ZyXEL NWD210N as the wireless client which connects to the notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the ZyXEL Device. A
wireless client must also use the same PIN in order to download the wireless network settings
from the ZyXEL Device.
Push Button Configuration (PBC)
Make sure that your ZyXEL Device is turned on and your notebook is within the cover range of the
1
wireless signal.
Make sure that you have installed the wireless client driver and utility in your notebook.
2
In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button
3
(Start or WPS button).
Push and hold the WPS button located on the ZyXEL Device's front panel for more than 5 seconds.
4
Alternatively, you may log into ZyXEL Device's web configurator and go to the Network Settings
> Wireless > WPS screen. Enable the WPS function and click Apply. Then click the Connect
button.
46
P-873HNUP-51B User's Guide
Advertisement
Table of Contents
