The Class Setup Screen - ZyXEL Communications EMG2881-T20A User Manual

The following table describes the labels in this screen.
Table 34 Management > Bandwidth MGMT > Queue Setup: Add/Edit new queue
LABEL
Active
Name
To Interface
Priority
Back
Apply
Cancel

9.5 The Class Setup Screen

Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows according
to specific criteria such as the source address, destination address, source port number, destination port
number or incoming interface. For example, you can configure a classifier to select traffic from the
same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the EMG2881-T20A forwards out through the WAN
interface. Give high priority to voice and video to make them run more smoothly. Similarly, give low
priority to many large file downloads so that they do not reduce the quality of other applications.
Click Configuration > Applications > Bandwidth Management > Class Setup to open the following
screen.
Figure 44 Configuration > Applicatioin > Bandwidth Management > Class Setup
The following table describes the labels in this screen.
Table 35 Configuration > Applications > Bandwidth Management > Class Setup
LABEL
Add new Classifier
#
Status
Class Name
Chapter 9 Applications
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue. Note that \"<>%\\^[]`\+\$\,='#&@.:() are not
allowed.
Select the interface to which this queue is applied.
Select the priority level (from 1 to 7) of this queue.
The smaller the number, the higher the priority level. Traffic assigned to higher priority queues
gets through faster while traffic in lower priority queues is dropped if the network is congested.
Click this to return to the previous screen.
Click this to save your changes.
Click this to exit this screen without saving.
DESCRIPTION
Click this to create a new classifier.
This is the index number of the entry.
This field displays whether the classifier is active or not. A yellow bulb signifies that this
classifier is active. A gray bulb signifies that this classifier is not active.
This is the name of the classifier.
EMG2881-T20A User's Guide
80