Table of Contents
Advertisement
Chapter 15 Firewall
Table 71 Security Settings > Firewall > Access Control > Add/Edit (continued)
LABEL
Select Source
Device
Source IP Address
Select Destination
Device
Destination IP
Address
Select Protocol
Protocol
Custom Source Port This field is displayed only when you select Specific Protocol in Select
Custom Destination
Port
Policy
Direction
Enable Rate Limit
Scheduler Rules
Apply
Cancel
202
DESCRIPTION
Select the source device to which the ACL rule applies. If you select Specific
IP Address, enter the source IP address in the field below.
Enter the source IP address.
Select the destination device to which the ACL rule applies. If you select
Specific IP Address, enter the destiniation IP address in the field below.
Enter the destination IP address.
Select the transport layer protocol that defines your customized port from the
drop-down list box. The specific protocol rule sets you add in the Security
Settings > Firewall > Protocol > Add screen display in this list.
If you want to configure a customized protocol, select Specific Protocol.
This field is displayed only when you select Specific Protocol in Select
Protocol.
Choose the IP port (TCP/UDP, TCP, UDP, or ICMP) that defines your
customized port from the drop-down list box.
Protocol.
Enter a single port number or the range of port numbers of the source.
This field is displayed only when you select Specific Protocol in Select
Protocol.
Enter a single port number or the range of port numbers of the destination.
Use the drop-down list box to select whether to discard (DROP), deny and
send an ICMP destination-unreachable message to the sender of (REJECT) or
allow the passage of (ACCEPT) packets that match this rule.
Use the drop-down list box to select the direction of traffic to which this rule
applies.
Select this check box to set a limit on the upstream/downstream transmission
rate for the specified protocol.
Specify how many packets per minute or second the transmission rate is.
Select a schedule rule for this ACL rule form the drop-down list box. You can
configure a new schedule rule by click Add new rule. This will bring you to the
Security Settings > Scheduler Rules screen.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
P-873HNUP-51B User's Guide
Advertisement
Table of Contents
