Chapter 11 Quality of Service (QoS)
11.4.1 Adding a QoS Queue
Click the Add button or the edit icon in the Queue Setup screen to configure a queue.
Figure 64 QoS Queue Setup: Add
The following table describes the labels in this screen.
Table 39 QoS Queue Setup: Add
LABEL
Active
Queue Name
Queue
Interface
Queue
Precedence
Back
Apply
Cancel
11.5 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the ZyXEL Device forwards out through the
WAN interface. Give high priority to voice and video to make them run more smoothly.
Similarly, give low priority to many large file downloads so that they do not reduce the quality
of other applications.
Click QoS > Class Setup to open the following screen.
120
DESCRIPTION
Select to enable or disable this rule.
Enter the descriptive name of this rule.
Select the interface to which this rule is applied.
Select the priority queue of this rule.
The smaller the number, the higher the priority level.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the ZyXEL Device.
Click Cancel to begin configuring this screen afresh.
P-870HW-51a v2 User's Guide