Table of Contents
Advertisement
Chapter 16 Quality of Service (QoS)
Table 74 Advanced > QoS > General
LABEL
Traffic priority
will be
automatically
assigned by
Apply
Cancel
16.4 The Class Setup Screen
Use this screen to add, edit or delete classifiers. A classifier groups traffic into data
flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
example, you can configure a classifier to select traffic from the same protocol
port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 113 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
Table 75 Advanced > QoS > Class Setup
LABEL
Create a new
Class
No
258
DESCRIPTION
These fields are ignored if traffic matches a class you configured in the
Class Setup screen.
If you select ON and traffic does not match a class configured in the
Class Setup screen, the P-660HN-F1A assigns priority to unmatched
traffic based on the IEEE 802.1p priority level, IP precedence and/or
packet length. See
Section 16.10.4 on page 271
If you select OFF, traffic which does not match a class is mapped to
queue two.
Click this to save your changes.
Click this to restore your previously saved settings.
DESCRIPTION
Click Add to create a new classifier.
This is the number of each classifier. The ordering of the classifiers is
important as the classifiers are applied in turn.
for more information.
P-660HN-F1A User's Guide
Advertisement
Table of Contents
