Table of Contents
Advertisement
Chapter 7 Wireless
The following table describes the labels in this screen.
Table 18 Wireless > MAC Authentication
LABEL
SSID
MAC List
Add new
MAC address
#
MAC Address
Modify
Apply
Cancel
7.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your ZyXEL Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Note: The ZyXEL Device applies the security settings of the SSID1 profile (see
7.2 on page
security mode of SSID1 to WPA-PSK, WPA2-PSK or No Security.
98
DESCRIPTION
Select the SSID for which you want to configure MAC filter settings.
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Allow to permit access to the ZyXEL Device. MAC addresses not listed will be
denied access to the ZyXEL Device.
Select Deny to block access to the ZyXEL Device. MAC addresses not listed will be
allowed to access the ZyXEL Device.
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to
the ZyXEL Device in these address fields. Enter the MAC addresses in a valid MAC
address format, that is, six hexadecimal character pairs, for example,
12:34:56:78:9a:bc.
This is the index number of the entry.
This is the MAC addresses of the wireless devices that are allowed or denied access to
the ZyXEL Device.
Click the Delete icon to delete the entry.
Click Apply to save your changes.
Click Cancel to exit this screen without saving.
Section 7.7.8.3 on page 109
88). If you want to use the WPS feature, make sure you have set the
for more information about WPS.
P-873HNUP-51B User's Guide
Section
Advertisement
Table of Contents
