The browser will be used to access the Internet and/or access the P-873HNUP-51B’s Web Configurator. Hardware Setup Place the P-873HNUP-51B flat on a desk or table or on the stand for a vertical installation. Remove the P-873HNUP-51B’s clear plastic covers before using it.
Page 5
1. Attach the antenna and point it up. 2. Do one of the following for your Internet connection: a. DSL 1,2: Use a telephone cable to connect your P-873HNUP-51B’s DSL1 port to a telephone jack (or the DSL or modem jack on a splitter if you have one).
Set Up a Wireless Network You can set up a wireless network using the following methods: Using Wireless Protected Setup (WPS) Press the WPS button on the P-873HNUP-51B’s front panel for more than 5 seconds to turn the WPS function on.
Page 7
Set Up a Wireless Network Manually The wireless LAN on your P-873HNUP-51B is enabled by default. To add a wireless client to the network, use the settings found on the side panel of your P-873HNUP-51B, which will look similar to the following example:...
The Web Configurator The Web Configurator is a web browser tool that allows you to configure the P- 873HNUP-51B. The computer and the P-873HNUP-51B need to be in the same IP address range to use this tool. 1. Open your browser and enter http://192.168.1.1 (the P-873HNUP-51B’s default IP address) as the address.
Page 9
3. A welcome screen appears with details about your last login. Select Show this page next time to see the welcome screen on your next login. Otherwise, clear it. Click Continue. 4. The Network Map page appears. This shows whether the P-873HNUP-51B and computers/devices connected to it have Internet access.
Page 10
5. Click Status to display the following screen, where you can view the P- 873HNUP-51B’s device, interface, and system information.
Page 11
P-873HNUP-51B 6. Click Quick Start and configure the P-873HNUP-51B’s time zone Internet access, and wireless settings. See your User’s Guide for how to use the rest of the Web Configurator screens. You will need to refer to the section on how to setup the Broadband connection if the INTERNET LED (light) remains off.