The Reset Button - ZyXEL Communications P873HNUP User Manual

802.11n wireless vdsl2 4-port gateway
Hide thumbs Also See for P873HNUP:
Table of Contents

Advertisement

Chapter 1 Introducing the P-873HNUP-51B
Table 1 LED Descriptions (continued)
LED
ETHERNET
WAN
USB
DSL1,2
INTERNET
HPNA
WLAN/WPS

1.6 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET
button at the back of the device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously and the password will be reset to "1234".
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for ten seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink,
the defaults have been restored and the device restarts.
26
COLOR
STATUS
DESCRIPTION
Green
On
The Gigabit Ethernet connection is working.
Blinking
The ZyXEL Device is sending or receiving data to/from the
Gigabit Ethernet link.
Off
There is no Gigabit Ethernet link.
Green
On
The ZyXEL Device recognizes a USB connection.
Blinking
The ZyXEL Device is sending/receiving data to /from the USB
device connected to it.
Off
The ZyXEL Device does not detect a USB connection.
Green
On
The ADSL line is up.
Blinking
The ZyXEL Device is initializing the ADSL line.
Off
The ADSL line is down.
Orange
On
The VDSL line is up.
Blinking
The ZyXEL Device is initializing the VDSL line.
Off
The VDSL line is down.
Green
On
The ZyXEL Device has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by
a DHCP server), PPP negotiation was successfully completed (if
used) and the DSL connection is up.
Blinking
The ZyXEL Device is sending or receiving IP traffic.
Off
There is no Internet connection or the gateway is in bridged
mode.
Green
On
The ZyXEL Device is connected to an HPNA-equipped device
through the coaxial cable.
Blinking
Data is transmitting over the HPNA cable.
Off
No HPNA device is connected.
Green
On
The wireless network is activated.
Blinking
The ZyXEL Device is communicating with other wireless clients.
Green
Blinking
The ZyXEL Device is setting up a WPS connection.
and
Orange
Off
The wireless network is not activated.
P-873HNUP-51B User's Guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

P-873hnup-51b

Table of Contents