Upper/Lower Comparator Function - A&D HW-10KGL Instruction Manual

11. Upper/Lower Comparator Function

This function compares a weight value with the upper limit (HI) and the lower limit
(LO) and displays the results.
To use this function, set the "Comparator function (
function table, upper limit value (HI) and lower limit value (LO).
Install option OP-03 or OP-04 to use relay output of the comparator.
Install option OP-03 to use buzzer output of the comparator.
The settings are stored in the scale even if the power is removed. (Refer to Caution
on the next page.)
Comparator Indicators
Comparison results are displayed by indicators
Comparison Condition
Weight value
Lower limit value ≦ Weight value ≦ Upper limit value......OK is displayed and output.
Upper limit value ＜ Weight value ........................................HI is displayed and output.
Parameter List and Word Definition
The decimal point is not displayed in the upper or lower limit value settings.
The " nearly-zero " is within ±5 digits from the zero point in the unit of kg.
Function table
f6 0
f6 1
f6 2
f6 3
f6 4
f6 5
f6 6
11. Upper/Lower Comparator Function
＜ Lower limit value ..................................LO is displayed and output.
Press the
SET
Press the key again to stop the comparison.
SET
The scale always compares the weight value.
Press the key to always compare the weight value when not
SET
nearly-zero.
Press the key again to stop the comparison.
SET
The scale always compares the weight value when not nearly-zero.
When the weight value becomes stable after the
pressed, the scale compares the weight value. It does not compare on
an unstable condition. Press the
comparison.
When the weight value is stable, the scale compares the weight
value. It does not compare on an unstable condition.
When the weight value becomes stable and not nearly-zero after
pressing the
SET
not compare on an unstable condition.
Press the key again to stop the comparison.
SET
f6 0
Description
key to compare the current weight value always.
SET
key, the scale compares the weight value. It does
Page 36
to )" parameters in the
f6 7
or
key is
SET
key again to stop the
HV-G/HW-G Series
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A