Display And Symbols - A&D HW-10KGL Instruction Manual

6.1.

Display and Symbols

Weighed mass value
STABLE
ZERO
HV-G/HW-G Series
Display and Symbols
Stability mark
When the current weight value is stable, this mark is
displayed. It means a proper condition that this value is
readable.
Zero point mark
When the
this mark is displayed. The zero point is the fundamental
starting point to weigh anything.
Net mark
When the
Used to indicate that the mass of the container placed
on the pan has been subtracted from the gross value.
Preset tare mark
While a tare with digital input is displayed, this mark
blinks.
Accumulation mark
While the accumulation function is used, this mark is
displayed.
Low battery mark for type L
When the battery is depleted (becoming low voltage),
this mark is displayed. Replace with six new batteries.
Ready mark for the full/dribble batch function. This mark
means as follows:
ON
OFF
Blinking
Weighing range indicator for the HV-G series
The current range is indicated.
Comparator indicator
unit
Zero point (Example)
When the
the zero point mark and the stability mark are displayed.
Description
key is pressed with nothing on the pan,
ZERO
key is pressed, this mark is displayed.
TARE
The weight value is within the zero band.
The full/dribble batch process is above the
zero band.
The start or end of the full/dribble batch
process is not within the zero band.
Using the comparator function:
Indicates the result after a weight value is
compared with the upper and lower limits.
Using the full/dribble batch function:
OK is the full flow gate indicator, HI is the dribble
flow gate indicator and LO is the zero band gate
indicator.
key is pressed with nothing on the pan,
ZERO
Page 19
6. Description of Each Part
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A
A