Example Of Setting Parameters - A&D HW-10KGL Instruction Manual

16.3.2. Example of Setting Parameters

Step 1 Turn off the display.
Press and hold the
The function table is displayed.
Step 2 Press the
Select a parameter of "Baud rate" with the
Step 3 Press the
mode").
Select "Command mode ( f5 1 )" with the
Step 4 Press the
Select "Format 1 ( f15 0 )" with the
Step 5 Press the
Step 6 Press the
The scale returns to the normal weighing mode.
Step 7 When the computer transmits a command, the scale
replies.
HV-G/HW-G Series
key and press the
ZERO
key to display f4 ("Baud rate").
ENTER
key to display
ENTER
key to display f15 ("Format").
ENTER
key to display end .
ENTER
key to store the new parameters.
ENTER
key.
ON/OFF
key.
∧
f5 ("Output
key.
∧
key.
∧
Page 63
16. RS-232C Serial Interface