A&D HW-10KGL Instruction Manual page 74

Zero
The current mass value is set to the zero point.
This is the same as the
Template
Command
Reply
Tare
With a tare (container) placed, the current mass value is set to zero, and the net is
displayed. This is the same as the
Template
Command
Reply
Cancel of tare
The weight value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template
Command
Reply
Preset tare
The tare value is set and the net is displayed. The net mark is displayed.
The set value is a 5 digit numerical value with a polarity sign and does not contain a
decimal point.
Template
Command
Reply
Upper limit value
The upper limit value is stored. The set value is a 5 digit numerical value with a
polarity sign and does not contain a decimal point.
Template
Command
Reply
Caution The upper limit value must be greater than the lower limit value.
Lower limit value
The lower limit value is stored. The set value is a 5 digit numerical value with a polarity
sign and does not contain a decimal point.
Template
Command
Reply
Caution The lower limit value must be less than the upper limit value.
17. Options
key.
ZERO
Z
The mass value becomes zero and zero point mark is displayed.
T
The current mass value becomes zero and the net mark is displayed.
CT
Gross is displayed and the net mark is turned off.
PT, [parameter]
Net is displayed and the net mark is displayed.
HI, [parameter]
The upper limit value is stored.
LO, [parameter]
The lower limit value is stored.
key.
TARE
Page 72 HV-G/HW-G Series