Removing The Pole; Procedure A - A&D HW-10KGL Instruction Manual

Hv-g/hw-g series digital platform scale

Hide thumbs Also See for HW-10KGL:

Instruction manual (71 pages)

Instruction manual (71 pages)

Table Of Contents

Table of Contents

5.3.

Caution

Remove the AC plug from the receptacle before removing the pole (type V).

Remove the AC adapter and batteries before removing the pole (type L).

When removing the load cell cable, do not pull on the load cell cable

connector forcibly and do not pull on the wires of the cable.

Do not bend the cable forcibly. Use care so that the load cell cable does not

touch the pan inside the base unit.

Avoid dust, static electricity and high humidity (or condensation) because the

inside of the display unit is sensitive.

The pole removing procedure depends on the scale model. Refer to the table below.

Models

HV-15KGL/HV-15KGV/HV-60KGL/HV-60KGV/HV-200KGL/HV-200KGV/HW-10KGL

HW-10KGV/HW-60KGL/HW-60KGV/HW-100KGL/HW-100KGV/HW-200KGL/HW-200KGV

HW-300KGL4/HW-300KGV4/HW-600KGL4/HW-600KGV4/HW-600KGL3/HW-600KGV3

HW-1200KGL3/HW-1200KGV3

5.3.1. Procedure A

Step 1 Turn the scale off.

Remove the AC plug from the receptacle (type V).

Remove the AC adapter and batteries (type L).

Step 2 Open the rear cover of the display unit.

Disconnect the load cell cable connector gently

(perpendicularly and do not pull toward you).

Step 3 Remove the two 4 mm screws, which are used

to attach the display unit to the pole.

Step 4 Remove the ferrite core and the cable clamp

from the load cell cable.

Step 5

(HV-60KGL/HV-60KGV/HW-60KGL/HW-60KGV/HV-

200KGL/HV-200KGV/ /HW-100KGL/HW-100KGV

HW-200KGL/HW-200KGV only)

Remove the 3 mm screws from the bottom

cover of the bracket.

Step 6 Carefully remove the load cell cable from the

pole and the bracket while using care not to pull

on the connector forcibly.

Step 7 Arrange the cable so that it does not touch the

pan in the base unit. The untied cable is

approximately 2 m. The optional extension load

cell cable (OP-02) is 5 m long.

Step 8 Remove the bracket from the base unit. An

Allen wrench is required.

HV-15KGL/HV-15KGV

HV-60KGL/HV-60KGV

HW-10KGL/HW-10KGV

HW-60KGL/HW-60KGV

5 mm Allen wrench

5. Installing the Scale