Full/Dribble Batch Function - A&D HW-10KGL Instruction Manual

12. Full/Dribble Batch Function

This function changes the scale to a filling machine which sub-divides a bulk product
( like grain) into loads of predetermined and virtually constant mass.
To use this function, set the parameter of the "Comparator function (
" Full/dribble batch sub-function (
(HI), preliminary value (OK) and zero band (LO).
Install option OP-03 or OP-04 to use the relay output of the full/dribble batch function.
In case of building up a filling machine with a scale and hopper, the performance is as
follows:
The settings are stored in the scale even if the power is removed. (Refer to Caution
on the next page.)
Gross ＜ Zero band
Net ＜ Final - Preliminary
Final - Preliminary ≦ Net ＜ Final
Final ≦ Net
12. Full/Dribble Batch Function
f10 0
LO relay output
(Zero detection Level)
OFF / Break
OFF / Break
OFF / Break
Page 40
to )" in the function table, final value
f10 3
Zero band Preliminary value
indicator/ indicator/
OK relay output
ON / Make OFF / Break
ON / Make
OFF / Break
OFF / Break
)",
f6 9
A
Final value
A
indicator/
HI relay output
A
A
OFF / Break
A
ON / Make
A
ON / Make
A
OFF / Break
HV-G/HW-G Series