Command Mode; Command List - A&D HW-10KGL Instruction Manual

16.3. Command Mode

The command mode is the function which can perform "outputting data", "controlling
the scale" and "setting parameters" by a command transmitted from a computer
Caution Allow at least 500 milliseconds between commands.

16.3.1. Command List

The following explanation uses "Format 1 ( f15 0 )"
Data output
The current weighing data is output.
Template
Command
Reply
Selection of mode and unit
Selects the mode and unit. This is the same as the
Template
Command
Reply
Zero
The current mass value is set to the zero point.
This is the same as the
Template
Command
Reply
Tare
With a tare (container) placed, the current mass value is set to zero, and the net is
displayed. This is the same as the
Template
Command
Reply
Cancel of tare
The weight value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template
Command
Reply
16. RS-232C Serial Interface
Q
U
The scale changes mode and unit.
key.
ZERO
Z
The mass value becomes zero and the zero point mark is displayed.
T
The current mass value becomes zero and the net mark is displayed.
CT
Gross is displayed and the net mark is turned off.
MODE
key.
TARE
Page 60
key.
HV-G/HW-G Series