Procedure C - A&D HW-10KGL Instruction Manual

5.1.3. Procedure C

HW-600KGL3/HW-600KGV3
HW-1200KGL3/HW-1200KGV3
Note The display unit, the pole and the base unit
are connected using cables. So, use care
when lifting the display unit.
Step 1 Take the scale out.
The pole, the display unit and the
accessories are found inside the base
unit.
Step 2 Remove the pan and the accessories.
Step 3 Attach the pole to the display unit with two
4 mm screws.
Attach the cable clamps on the back of the
pole to organize the cables.
Step 4 Attach the pole to the base unit with four
Allen screws and plain washers, while
using care not to damage the load cell
cable.
Using the cable tie, collect and bundle the
remainder of the load cell cable.
Step 5 Replace the pan in the direction as shown
in the illustration.
Step 6 Select a place for installing the scale.
Refer to "4.1. Installing the Scale" .
Step 7 Adjust the level of the base unit using the
leveling feet.
Note A bubble spirit level is not provided. (The
load values on the four corners
added.)
Step 8 Press the caps at the pole top from both
sides and adjust the angle of the display
unit.
Step 9 Check the weighing accuracy. If the scale
needs
Calibration".
5. Installing the Scale
calibration, refer
are
to "14.
Page 12 HV-G/HW-G Series