Procedure B - A&D HW-10KGL Instruction Manual

5.1.2. Procedure B

HW-300KGL4/HW-300KGV4
HW-600KGL4/HW-600KGV4
Note The display unit, the pole and the base unit
are connected using cables. So, use care
when lifting the display unit.
Step 1 Take the base unit, pole and display unit
out, taking care not to pull on the load cell
cable.
Step 2 Remove the pan.
Step 3 Attach the pole to the display unit with two
4 mm screws.
Attach the cable clamps on the back of the
pole to organize the cables.
Step 4 Attach the pole to the base unit with four
Allen screws and plain washers, while
using care not to damage the load cell
cable.
Using the cable tie, collect and bundle the
remainder of the load cell cable.
Replace the pan.
Step 5 Affix the pan using the 5 mm screws.
Step 6 Select a place for installing the scale.
Refer to "4.1. Installing the Scale" .
Step 7 Adjust the level of the base unit using the
bubble spirit level and the leveling feet.
Step 8 Press the caps at the pole top from both
sides and adjust the angle of the display
unit.
Step 9 Check the weighing accuracy. If the scale
needs
Calibration".
HV-G/HW-G Series
calibration, refer to "14.
Page 11
5. Installing the Scale