Parameter List - A&D HW-10KGL Instruction Manual

15.2. Parameter List

Item Display
Automatic
f1 0 #
turning off
f1 1
Weighing
f2 0 #
range
f2 1
f3 0 #
f3 1
Unit
f3 2
f3 3
f4 0 #
Baud rate
f4 1
f4 2
f5 0 #
f5 1
f5 2
f5 3
Output
mode
f5 4
f5 5
f6 0 #
f6 1
Comparator
f6 2
f6 3
"#" :factory settings. The "nearly-zero" is within ±5 digits from zero point in the unit of kg.
15. The Function Table
The type L scale is turned off after 5 minutes of no operation,
when zero is displayed.
Not used
Used
Selects how to change the weighing range for HV-L and HV-G
series.
Automatic range
Manual range
Selects the first unit at the time when the scale turns on.
Kg
Lb
Oz
lb-oz
Selects the transmission rate of the serial interface (RS-232C/ 422/485).
2400 bps
4800 bps
9600 bps
Selects the mode for the serial interface (RS-232C/ 422/485).
Stream mode. (Refer to "16.2. Stream Mode")
Command mode. (Refer to "16.3. Command Mode")
A data is output, when the
Auto-print +
When the display becomes a positive stable value and not
nearly-zero, the scale outputs the data automatically. Next
output can be performed after the display becomes
nearly-zero or a negative value.
Auto-print +/-
When the display becomes a stable value and not
nearly-zero, the scale outputs the data automatically. Next
output can be performed after the display becomes
nearly-zero.
At each end of full/dribble batch function, the data is output.
Selects the comparator mode.
Press the key to always compare the current weight value.
SET
Press the key again to stop the comparison.
SET
The scale always compares the weight value.
Press the key to always compare the weight value when not
SET
nearly-zero. Press the
The scale always compares the weight value when not
nearly-zero.
Page 52
Description
key is pressed.
PRINT
key again to stop the comparison.
SET
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
Ａ
A
A
A
A
A
A
HV-G/HW-G Series