Comparator Function; Setting The Comparator - A&D GC Series Instruction Manual

12. Comparator Function

The comparator function compares the number of pieces or weight with upper limit or lower limit. The
comparison result is shown in 3 phases as "LO", "OK", or "HI". The buzzer can be set to ring according to the
result.
Divided into three phases based on the two comparison
values of HI limit (upper limit) and LO limit (lower limit)
To use the comparator function, the function setting and upper/lower limits need to be set. For the
comparator setting, refer to

12.1. Setting the Comparator

In function setting
Setting value
In function setting
Setting value
In function setting
" " : Turn off buzzer
" " : Turn on buzzer
LO OK HI
X in
, set the comparison mode.
Description
Turn off the comparator function
Compare all data
Compare stable data
Compare all data except for near zero
Compare stable data except for near zero
Compare positive data except for near zero
Compare positive stable data except for near zero
, set the comparison data.
Description
Compare data of the number of pieces
Compare data of the weight
, set the buzzer to ring according to the comparison result.
The RESET key does not delete upper/lower limits.
Turning the power off does not delete upper/lower limits.
赤
Red
LO
"13.2. Sensitivity Adjustment Using a
Example)
OK to turn on the buzzer, HI and LO to turn off the buzzer
(Buzzer keeps ringing while OK)
32
緑 黄
Green Yellow
OK HI
HI
LO
LO HI
limit 限界値 limit
限界値
Weight".