Stop Mode - Fujitsu MB91460 SERIES FR60 User Manual

Chapter 16 Clock Supervisor
4.Operation Modes

■ Stop mode

If RC-oscillator, main clock and sub-clock supervisors are enabled, they will be automatically disabled at
transition into stop mode. The corresponding enable bits in the clock supervisor control register remain
unchanged. So after wake-up from stop mode the RC-oscillator and the clock supervisors will be enabled again. If
the corresponding enable bits are set to '0', the RC-oscillator and the clock supervisors will stay disabled after
wake-up from stop mode.
• The RC-oscillator is enabled immediately after wake-up from stop mode.
• The main clock supervisor is enabled after the 'oscillation stabilisation wait time' with the rising edge of the
signal OSC_STAB or in case the main clock is missing after wake-up from stop mode, after the 'main clock
timeout' (TO_MCLK) from the timeout counter. The timeout counter is clocked with RC-oscillation clock.
• The sub-clock supervisor is enabled after the 'sub-clock timeout' (TO_SCLK) from the timeout counter which is
clocked with the RC-oscillation clock.
PONR
MCLK
SCLK
RCE
RC_CLK
OSC_STAB
TO_MCLK
TO_SCLK
MSVE
MSEN
SSVE
SSEN
MCLK_STBY
SCLK_STBY
SRST
EXT_RST
EXT_RST_OUT
MCLK_OUT
SCLK_OUT
MCLK_MISSING
SCLK_MISSING
Clock Mode
236
Figure 4-11 Timing Diagram: Waking up from stop mode
Main Stop Main