1.1.5
Configuring the evaluation board and connecting it to the PC
After SOFTUNE installation, configure a switch on the board and then connect it to the PC.
Set the "MODE" selector on the board to "PRG".
MODE selector
PRG
RUN
Make sure that the MODE selector is set to "PRG".
Then, connect it to the PC.
Figure 1-23 MODE selection
Operation
FLASH memory serial write mode
→Used to write a program into the microcontroller.
Single ship mode
→Used to run the program written into it.
- 33 -
AN07-00180-3E
Set the MODE selector to
"PRG".