Operation - Fujitsu MB91460 SERIES FR60 User Manual

5. Operation

This section describes the events that trigger an oscillation stabilization wait and the operation in each case.
5.1 INIT Pin Input
An oscillation stabilization wait is required after power on. As the wait time provided by the initialized timebase
counter is too short, the INIT pin input must be held at the "L" level.
Figure 5-1 Using the Width of the Pin Input to Provide the Oscillation Stabilization Wait Time
Using the INIT pin input to trigger
a reset and provide the oscillation
stabilization wait time for the
main clock
Example power-on Vcc
Example main clock startup
Time-base
counter count
000h
1
2 (Bit 0 output)
INIT pin input
State transition
(1) Power turned on
(2) Start INIT pin input (Settings initialization reset)
(3) Main clock oscillation starting
(4) INIT pin input (to provide a sufficient time for the main clock oscillation to stabilize)
(5) INIT pin input removed. The timebase counter is initialized and starts counting.
(6) Oscillation stabilization wait time provided by timebase timer/counter (Initial value = minimum value)
(If the INITX pin input (4) is not maintained, the wait time is too short.)
(7) Operation initialization reset, reset cancellation sequence
(8) Main RUN
■ INIT Pin input when main clock running
The device goes to the operation initialization reset (RST) state automatically after the minimum oscillation
stabilization wait time elapses.
(1)
(3)
Provide a sufficient oscillation
stabilization wait time
1
2
(2)
(2)
Undefined
Oscillation stabilization wait reset
Settings initialization
(INIT)
(5)
Initial value of oscillation
(6)
stabilization wait time is too short
(5)
(4)
(7) (8)
Operation initialization (SRST)
Reset cancellation sequence
Chapter 18 Timebase Counter
Time
Main RUN
5.Operation
253