Sdram/Fcram Interface Operation - Fujitsu MB91460 SERIES FR60 User Manual

Chapter 31 External Bus

9.SDRAM/FCRAM Interface Operation

9. SDRAM/FCRAM Interface Operation
This section describes the operations of the SDRAM/FCRAM interface.
■ SDRAM/FCRAM interface
The chip select areas can be used as SDRAM/FCRAM interface by setting the TYP3 to TYP0 bits in the area
configuration register (ACR) to 100X
This section provides timing charts to describe the following operations of the SDRAM/FCRAM interface.
• Burst read/write (Settings: Page hit, CAS latency 2)
• Single read/write (Settings: Page hit, CAS latency 3, auto - precharge OFF)
• Single read (Settings: Page miss, CAS latency 3, auto - precharge OFF)
• Single read/write (Settings: CAS latency 1, TYP 1001
• Auto - refresh
■ Burst Read/Write Operation Timing
Figure 4.9 - 1 shows the operation timings assuming that page hits and CAS latency 2 are set.
MCLK
A
D
SRAS,SCAS,
SWE
• All of the A13 to A0 pins may not be used depending on the SDRAM capacity. See Section " Memory
Connection Examples " .
• The MCLK is a clock signal input to SDRAM. Signals such as addresses, data, and commands are input to
SDRAM at the rise of the MCLK.
• Set the W05 and W04 bits in the area wait register (AWR) to the write recovery cycle according to the
SDRAM/FCRAM standards.
• Set the W10 to W08 bits in the area wait register (AWR) to the CAS latency according to the SDRAM/FCRAM
standards.
• Set the burst length using the BST bit in the area configuration register (ACR).
■ Single Read/Write Operation Timing
Figure 9-2 shows the operation timings assuming that page hits, CAS latency 3, and no auto - precharge are set.
582
.
B
Figure 9-1 Burst Read/Write Timing Chart
#1
#1
#2 #3 #4
WRIT
Write recovery
Write cycle
, auto - precharge ON)
B
#1
#1
READ
Cas Latency
#2 #3 #4
Read cycle