Ricoh SP 5200S Operating Instructions Manual page 79

Shielded Twisted Pair Cable (STP) and Category type 5e or more
1. Make sure the main power is switched off.
2. Connect the Ethernet interface cable to the Gigabit Ethernet port.
3. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4. Turn on the main power switch of the machine.
1. Indicator (green)
When 10BASE-T is operating, the LED is lit green. When 100BASE-TX is operating or the machine is not
connected to the network, it is turned off.
2. Indicators (both orange and green)
When 1000BASE-T is operating, both LED are lit.
3. Indicator (orange)
When 100BASE-TX is operating, the LED is lit orange. When 10BASE-T is operating or the machine is
not connected to the network, it is turned off.
• For details about how to turn on the main power switch, see "Turning On/Off the Power", About
This Machine.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
CFL008
1
2
3
CFL013
Connecting to the Interface
2
77