Ricoh SP 5200S Operating Instructions Manual page 266

5. Registering Addresses and Users for Facsimile/Scanner Functions
For details about how to specify the path using Browse Network, see "Locating the SMB folder
using Browse Network".
17. Press [Connection Test] to check the path is set correctly.
18. Press [Exit].
If the connection test fails, check the settings, and then try again.
19. Press [OK].
20. Press [Exit].
21. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
5
• You can enter a path using up to 128 characters.
• If User Authentication is specified, contact your administrator.
• p.229 "Registering Names"
• p.264 "Locating the SMB folder manually"
• p.265 "Locating the SMB folder using Browse Network"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
For example: if the name of the destination computer is "User", and the folder name is "Share", the
path will be \\User\Share.
264