Ricoh SP 5200S Operating Instructions Manual page 222

4. Monitoring and Configuring the Machine
SMTPC: failed to get smtp server ip-address.
4
SMTPC: no smtp server. connection close.
SMTPC: refused connect by smtp server.
SMTPC: username or password wasn't correct.
[response code] (information)
Snmp over IPv4 is ready.
Snmp over IPv6 is ready.
Snmp over IPX is ready.
Snmpd Start.
started.
started.
220
Message Problem and solutions
The SMTP server IP address could not be
obtained. This could be because:
• The specified DNS server could not be
found.
• No connection to the network has been
established.
• An incorrect DNS server is specified.
• The specified SMTP server IP address could
not be found in the DNS server.
Connection to the SMTP server failed due to no
response from SMTP. This could be because a
server other than the SMTP server has been
specified, or the specified SMTP server port
number is incorrect. Check the SMTP server
name, port number, or the SMTP server port
number.
Connection to the SMTP server is denied. This
could be because server other than the SMTP
server has been specified, or the specified SMTP
server port number is incorrect. Check the SMTP
server name, port number, or the SMTP server
port number.
Connection to the SMTP server failed, because
the specified SMTP user name is incorrect, or the
specified SMTP password is incorrect. Check the
SMTP user name and password.
Communication over IPv4 with snmp is available.
Communication over IPv6 with snmp is available.
Communication over IPX with snmp is available.
The snmpd has started. This message is displayed
only when the power is turned on.
The direct printing service has started.
The IKE service has started.