Ricoh SP 5200S Operating Instructions Manual page 181

• You can configure ten SNMP access settings numbered 1-10.
• The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor
for Client if "public" is not registered in numbers 1-10. When changing the community name,
use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings.
• The community name can be entered using up to 15 characters.
Deleting community name
msh> snmp "number" clear name
Access type configuration
msh> snmp "number" type "access_type"
Access type
no
read
write
trap
Protocol configuration
Use the following command to set protocols "active" or "inactive". If you set a protocol "inactive",
all access settings for that protocol are disabled.
"IPX" is shown only when the NetWare is installed.
msh> snmp {ipv4|ipv6|ipx} {on|off}
• Specify "ipv4" for IPv4, "ipv6" for IPv6, or "ipx" for IPX/SPX.
• {on} means "active" and {off} means "inactive".
• All protocols cannot be turned off concurrently.
Configuration of protocol for each registration number
"IPX" is shown only when the NetWare is installed.
msh> snmp "number" active {ipv4|ipv6|ipx} {on|off}
• To change the protocol of access settings, use the following command. However, if you have
disabled a protocol with the above command, activating it here has no effect.
Access configuration
"IPX" is shown only when the NetWare is installed.
msh> snmp "number" {ipv4|ipv6|ipx} "address"
• You can configure a host address according to the protocol used.
Remote Maintenance Using telnet
Type of access permission
not accessible
read only
read and write
user is notified of trapmessages
4
179