Ricoh SP 5200S Operating Instructions Manual page 77
Network and system settings reference
Hide thumbs
Also See for SP 5200S:
- Operating instructions manual (204 pages) ,
- Initial manual (48 pages) ,
- Service manual (667 pages)
Table of Contents
Advertisement
• If the main power switch is on, turn it off.
• Use the following Ethernet cables:
• When using 100BASE-TX/10BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
• When using 1000BASE-T:
Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5e or more
1.
Attach one ferrite core at the machine end of the Ethernet cable, and then attach the other
ferrite core about 10 cm (4.0 inches) (1) from this core.
2.
Make sure the main power is switched off.
3.
Connect the Ethernet interface cable to the Gigabit Ethernet port.
4.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
CFL019
CFL008
Connecting to the Interface
2
75
- Quick Links:
- Network
Hide quick links:
Advertisement
Table of Contents
