Connecting A Device To The Machine's Usb Host Interface; Connecting To The Wireless Lan Interface - Ricoh SP 5200S Operating Instructions Manual

Connecting a Device to the Machine's USB Host Interface

This section explains how to connect a device to the machine's USB host interface.
1. Connect one end of the USB interface cable to the machine's USB host interface.
2. Connect the other end of the USB interface cable to a card authentication device or media
slot.
• This machine does not come with a USB interface cable. Make sure you purchase the appropriate
cable.

Connecting to the Wireless LAN Interface

This section describes how to connect to the wireless LAN interface.
• Check the machine's IPv4 address and subnet mask, or the IPv6 address settings.
• For details about how to set the IPv4 address and subnet mask from the control panel of the
machine, see "Interface Settings".
• Before using this machine with a wireless LAN interface, you must select [Wireless LAN] in [LAN
Type].
• p.36 "Interface Settings"
Setup Procedure
This section describes how to setup wireless LAN interface.
To configure the wireless LAN settings: open [System Settings], [Interface Settings], select [Wireless
LAN], and then use the following procedure.
CFL010
Connecting to the Interface
2
79