Etherconfig; Help; Hostname - Ricoh SP 5200S Operating Instructions Manual

4. Monitoring and Configuring the Machine

etherconfig

Use the "etherconfig" command to view and configure the Ethernet parameters.
View settings
msh> etherconfig
Specify Ethernet Speed
msh> etherconfig speed {auto|10f|10h|100f|100h}
• auto=Auto Select
• 10f=10 Mbps Full Duplex
• 10h=10 Mbps Half Duplex
4
• 100f=100 Mbps Full Duplex
• 100h=100 Mbps Half Duplex
The default is "auto".

help

Use the "help" command to display the available command list and the procedures for using those
commands.
Command list display
msh> help
Display of procedure for using commands
msh> help "command_name"

hostname

Use the "hostname" command to change the printer name.
View settings
msh> hostname
IPv4 Configuration
msh> hostname "interface_name" name "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name beginning "RNP" (in either upper or lower case).
• The Ethernet interface and IEEE 802.11 interface will have the same printer name.
• wlan can be specified only when the IEEE 802.11 interface is installed.
164