Connecting The Machine; Connecting To The Interface - Ricoh SP 5200S Operating Instructions Manual

2. Connecting the Machine

This chapter describes how to connect the machine to the network and specify the network settings.

Connecting to the Interface

This section explains how to identify the machine's interface and connect the machine according to the
network environment.
• The standard Ethernet and USB2.0 ports are not available when the Gigabit Ethernet board is
installed into the machine. Use the Ethernet and USB2.0 ports on the Gigabit Ethernet board.
1. 10BASE-T/100BASE-TX port
Port for connecting the 10BASE-T or 100BASE-TX cable
2. Optional board slot
Install an optional interface board in this slot.
The slot can accommodate the file format converter or one of the following interface boards:
• Wireless LAN board: Required if you want to connect this machine to a wireless LAN. When installed,
this unit allows you to connect the machine to an IEEE 802.11 a or IEEE 802.11 b/g wireless LAN.
• Gigabit Ethernet board: Required if you want to connect the machine to a network using a 1000BASE-T,
100BASE-TX, or 10BASE-T cable.
3. USB 2.0 [Type B] port
Port for connecting the USB2.0 [Type B] interface cable
4. USB Host Interface
Port for connecting the USB interface cable
Use this interface to connect the machine to a card authentication device.
1
2
3
4
CFL006
2
71