Connecting To The Gigabit Ethernet Interface (Mainly Europe And Asia) - Ricoh SP 5200S Operating Instructions Manual
Network and system settings reference
Hide thumbs
Also See for SP 5200S:
- Operating instructions manual (204 pages) ,
- Initial manual (48 pages) ,
- Service manual (667 pages)
Table of Contents
Advertisement
2. Connecting the Machine
2.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
2
3.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4.
Turn on the main power switch of the machine.
1. Indicators
When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the
machine is not connected to the network, both LEDs are turned off.
• For details about how to turn on the main power switch, see "Turning On/Off the Power", About
This Machine.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
Connecting to the Gigabit Ethernet Interface
Asia)
This section describes how to connect the Ethernet interface cable to the Gigabit Ethernet port.
Caution:
A network interface cable with a ferrite core must be used for RF interference suppression.
74
CFL007
1
CFL014
(mainly Europe and
- Quick Links:
- Network
Hide quick links:
Advertisement
Table of Contents
