Ricoh SP 5200S Operating Instructions Manual page 218

4. Monitoring and Configuring the Machine
<Interface name> card removed
<Interface name> interface down
<Interface name> interface up
< Interface > started with IP: < IP address >
4
< Interface >: Subnet overlap.
IPP cancel -job: permission denied.
IPP job canceled. jobid=%d.
job canceled. jobid=< job ID >
LEAP challenge to access point failed
LeaseTime=<lease time>(sec),
RenewTime=<renew time>(sec).
Login to fileserver <file server name> (<IPX|IP>),
<NDS|BINDERY>
Manual [%s] is disable, set authentication key.
Manual [%s] is disable, set encryption key.
Memory allocate error.
216
Message Problem and solutions
The interface managed by the supplicant has
been removed.
The interface managed by the supplicant is
disabled, or cannot connect to the access point.
The interface managed by the supplicant is
enabled, or is connected to the access point.
IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
The same IP address (IPv4, or IPv6 address) and
the subnet mask is used with other device.
The spooled job was canceled due to error or
user request.
The spooled job was canceled due to error or
user request.
The spooled job was canceled due to error or
user request.
The LEAP challenge to the access point has failed.
The resource lease time received from the DHCP
server is displayed in [lease time] in seconds. The
renewal time is displayed in [renew time] in
seconds.
When the print server was online, the system
logged in to <file server> in NDS or BINDERY
mode. The transfer protocol in use is also
displayed.
The specified manual SA entry is invalid. Set the
authentication key.
The specified manual SA entry is invalid. Set the
authentication key.
Date cannot be obtained. Disconnect the USB
cable, and then connect it.