HP Cisco MDS 9216 - Fabric Switch Configuration Manual page 103

Chapter 2 Installation of Cisco MDS SAN-OS and Fabric Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configure NTP server? (yes/no) [n]: no
Enter shut (shut is the default) to configure the default switch port interface to the shut state.
Step 15
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter auto (off is the default) to configure the switch port trunk mode.
Step 16
Configure default switchport trunk mode (on/off/auto) [off]: auto
Enter off (off is the default) to configure the PortChannel auto-create state.
Step 17
Configure default port-channel auto-create state (on/off) [off]: off
Enter deny (deny is the default) to deny a default zone policy configuration.
Step 18
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
Enter no (no is the default) to disable a full zone set distribution (see the
Step 19
on page
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 20
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip address ip_address subnet_mask
no shutdown
ip default-gateway default_gateway
no telnet server enable
ssh key rsa 1024 force
ssh server enable
no system default switchport shutdown
system default switchport trunk mode auto
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Step 21 Enter yes (yes is default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]: yes
OL-8007-10, Cisco MDS SAN-OS Release 3.x
The management Ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
30-25).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Initial Setup Routine
"Zone Set Distribution" section
2-11