Honda Civic Service Manual page 1461

5.
Remove the screw from the field coil ground termi-
n a l , t h e n d i s c o n n e c t t h e f i e l d c o i l c o n n e c t o r .
R e m o v e s n a p r i n g A w i t h s n a p r i n g p l i e r s , t h e n
remove the field coil
NOTE:
.
Be careful not to damage the field coil and com-
pressor during remove/installation.
. Once snap ring A is removed, replace it with a
new one.
. When installing the field coil, align the boss on
the field coil with the hole in the compressor.
SNAP RING A
Replace.
Position the rotor pulley squarely over the field coil.
Press the rotor pulley onto the compressor boss
with the special tool. lf the rotor pulley does not
press on straight, remove it, and check the rotor
pulley and compressor boss for burrs or damage.
C A U T I O N : M a x i m u m p r e s s l o a d : 3 9 , 2 0 0 k P a
(,[00 kgf/cm', 5,590 Psi)
Press
T
HUB ASSEMBLY
GUIDE ATTACHMENT
07965 - 6920500
ROTOR
PULLEY
t ' l
i,'
7 . A s s e m b l e i n t h e r e v e r s e o r d e r o f d i s a s s e m b l y
Make note of the following items.
.
lnstall the field coil with the wire side facing down.
. C l e a n t h e r o t o r p u l l e y a n d c o m p r e s s o r s l i d i n g
surfaces with non-petroleum solvent.
. Make sure the snap rings are fully seated in the
groove.
.
Make sure that the rotor pulley turns smoothly
after it's reassembled
. Route and clamp the wires properly or they can
be damaged bY the rotor Pulley.
22-35