Honda Civic Service Manual page 1627

A/T Gear Position Switch
Replacement
1 .
2.
7 .
Remove the front console, then disconnect the
connector from the A/f gear position swltch
Remove the two mounting nuts
swrTcH
SLIDEB
MOUNT'NG NUTS
6 x 1 0 m m
9 8 N m ( 1 0 k g t m ' 7 l b l f t l
P o s i t i o n t h e s w i t c h s l i d e r t o
" N e u t r a l " a s s h o w n
above.
Move the shift lever to
"Neutral", then slip the switch
into position.
Aftach the swjtch with the two mounting nuts.
Test the switch in the E and E position ofthe shift
lever. The engine should start when the shift lever
is in position fl anywhere in the range of free play
Connect the 14P connector, clamp the harness, and
install the front console
14P
A/T Gear Position Switch
Adjustment
1 .
3 .
Shift to the E position, and loosen the nuts.
slide the switch in the direction of El or E position
lwithin 2.0 mm (0.079 in.)l so that there is continuity
between the No. 1 and No 7 terminals in the range
of free play of the shift lever'
Recheck for continuity between each of the termi-
n a t s .
NOTE:
.
lf adjustment is not possible, check for damage
t o t h e s h i f t l e v e r d e t e n t a n d / o r t h e b r a c k e t l f
there is no damage. replace the console switch
. The engine should start when the shift lever is in
position N in the range of free play
E position
A/T GEAR
POSITION SWITCH
D j r e c t i o n o f - o n , o r D l P o s i t i o n
lwithin 2.0 mm (0.079 in)1
F r e e p l a y
-lfr-
L O C K P I N
23-155