Honda Civic Service Manual page 1190

Rear Brake Caliper
Reassembly (cont'dl
'16. Installthe pad
spring onto the caliper.
Apply the recommended pin groase in the caliper
seal set to the sliding surface of the pins and inside
of the new pin boots.
Install the pin boots into the grooves in the caliper
bracket properly.
PIN BOOTS
Replsce.
(Bl.ck Colorl
PIN
Repl6ce.
19. Insert pin A and pin B into the caliper bracket.
20. Install the pin boots into the grooves in the
propefly.
PAD SPRING
1 1 .
PIN GREASE
1 9 - 3 4
p r n s
22.
21. Install the brake pad retainers and brake pads (see
page 19-25).
Align the cutout in the piston with the tab on the
inner pad (see page 19-25).
Install the caliper onto the caliper bracket. and tight-
en the caliper mounting bolts.
CALIPER MOUNTING BOLTS
23 N.m {2.3 kg{.m. 17 lbf.ft)
WASHERS
Replace.
BANJO BOLT
34 N.m
13.5 kg{.m.
25 rbtft)
24. Connect the brake hose to the caliper with new seal,
ing washers, and tighten the banjo bolt,
Insert ths cable through the arm, and connect the
cabls to the lever with the clevis pin and lock pin.
Install the cable clip securely.
CLEVIS PIN
- t
/ / t
LOCK PIN
Roplace.
26. Install the caliDer shield.
27. Fill the brake reservoir, and bleed the brake svstem
(see page 19-71.
28. Operate the brake pedal several times, then adjust
the parking brake (see page 19-6).
29. After installation, perform the following checks:
. Check for leaks at hose and line joints and con-
nections, and retighten if necessary.
. Check the parking brake lever for operation, and
adjust it if necessary.
. Check for brake hose for interference or twistinq.