Honda Civic Service Manual page 1151

T
1 1 .
1 )
Remove the two brake hose mounting bolts
R e m o v e t h e c a l i p e r b . a c k e t m o u n t i n g b o l t s , a n d
hang the caliPer to one side
CAUTION: To prevent accidental damage to the
caliper or brake hose, use a short piece of wile to
hang the caliper from the undercarriage.
BRAKE HOSE MOUNTING BOLTS
22 N'm {2.2 kgf'm, 16lbt"ft}
CALIPER
10 x 1.25 mm
38 N'm (3.9 kgf'm, 28 lbf'ftl
Screw two 8 x 1.25 mm bolts into the disc to push it
away from the hub.
NOTE: Turn each bolt two turns at a time to pre-
vent cocking the disc excessively.
Remove the brake disc.
Remove the hub unit bearing from the spindle
SPINOLE WAS}IER
l r
1 4 .
1 5 .
l t
16. lnstall in the reverse order of removal.
1A-25
Upper Arm Bushing RePlacement
1 . R e m o v e t h e u p p e r a r m b u s h i n g a n d u p p e r a r m
j n n e r b u s h i n g a s s h o w n
UPPER ARM INNER BUSHING
UPPER ARM BUSHING
REAR UPPER ARM
Scribe a line on the upper arm inner bushing so that
it is in line with the bolt mounting surface
Mark to points on the upper arm so that they are In
line and make a right angle with the arm as shown
in the drawing.
BOLT MOUNTING
SURFACE
Drive in the upper arm inner bushing with the marks
aligned.
Drive the upper arm bushing into the upper arm
NOTE: Drive in the upper arm bushing and upper
a r m i n n e r b u s h i n g u n t i l t h e i r l e a d i n g e d g e s a r e
flush with the uPPer arm
t t
I
5 .
UPPER ARM