Honda Civic Service Manual page 1048

l .
11. Set the double loop band onto the boot and dynam-
ic damper with the band end toward the front ot the
vehicle.
LOOP BANO
Pull up the slack in the band bY hand
Mark a position on the band 10 - 14 mm {0 4
- 0 6
i n ) f r o m t h e c l i P .
DOUBLE
,
1 ' )
1 3 .
CLIP
I p
1 4 .
1 5 .
Thread the free end of the band through the nose
section of the boot band tool and into the slot on
t h e w i n d i n g m a n d r e l .
Place a wrench on the winding mandrel of the boot
band tool, and tighten the band until the mark you
made on the band meets the edge of the clip.
Mark on band.
Lift up the boot band tool to bend the free end
the band 90 degrees, then center-punch the clip'
1 6 .
(cont'd)
1 6 - 1 3
(KD-3191 or equivalent)
HAMMER